The
TIP is the pure silver disk on the end of the unit. It is approximately
1/4 inch in diameter and is the surface that you use to treat
your skin. The CONTACT PLATE is the rectangular stainless steel
plate on the side of the unit. The LED is the green indicator
light.
Basic
Instructions for UseBefore you begin treatment, clean the area
of skin using soap and water.
Gently clean the silver tip using the emery board only. Apply
a thin, even layer of silver conductive gel to the silver tip.
Also apply a small dab of silver conductive gel to the finger
you will use to hold the unit. Hold the case so that the finger
with the conductive gel presses firmly against the stainless steel
contact plate.
Press
the silver tip to the area you wish to treat. The green LED indicator
will flash when the device is activated and working. You will
not feel any sensation from the unit even though it is operating
effectively.
Each
individual is unique and you will determine the best treatment
routine for your own situation. In some situations, you may want
to test slightly longer treatment times for a more aggressive
treatment. You may also use shorter treatment times if that works
well for you. DermaSeptic is very safe for a wide variety of treatment
times.

|